ITEMS ORDERED IN STOCK ARE SENT EVERY MONDAY, WEDNESDAY AND THURSDAY AT 12PM
$0.00 / 0 items
0
0
KTM85SX and Husky TC85 2018-on Complete Rebuild Kit – TSP

$613.80

KTM85SX and Husky TC85 2018-on Complete Rebuild Kit – TSP

$613.80

piston kit
KTM85 Piston 03-on PC1852
Piston Size
complete gasket set
KTM85 Full Gasket 18-on 007FL

In stock

connecting rod kit
KTM85 con rod 13-on 03.6113

Out of stock. If any items are backordered, your order will be sent all at once when items have arrived in stock

main bearings
Main Bearing KTM85 NJ205

In stock

main bearings
Main Bearing KTM85 6304/22

In stock

KTM85 Seal Kit 18-on 007SR

In stock

Out of stock. If any items are backordered, your order will be sent all at once when items have arrived in stock

Quantity

This TSP complete rebuild kit will suit KTM85SX and Husky TC85 models from 2018. It will also suit the Gas Gas MC85 2021 Model. Image is for illustration purposes only and you will receive the correct parts for your model.

It includes:

  • Piston kit in the size of your choice (A or B). Piston kit includes rings, pin, circlips and a high quality cast piston with anti-friction coating. These pistons are made in Italy and are THE BEST available.
  • Complete gasket kit. Made in Italy and packed especially for TSP. Includes a selection of base gaskets, powervalve cover gaskets and O rings… all O rings are the correct size and made from the correct material, unlike the cheaper aftermarket kits.
  • Genuine KTM/Husky centre case gasket
  • Pro X con rod kit (includes little end bearing). Made in Japan.
  • Left and Right main bearings. Usually NTN or KOYO. Made in Japan.
  • Complete engine seal kit. Made in Italy and packed especially for TSP. Includes all oil seals, crank seals, water pump seals, etc.

TSP rebuild kits are put together by TSP using parts sourced direct from OEM manufacturers in Japan and Europe. The parts we select are THE BEST available for each make/model and many are the exact same parts as the genuine items. All TSP rebuild kits are kept in stock at TSP.

Piston sizing: ideally you should measure your bore with a dial gauge to work out the correct piston sizing. If you cannot do this then a rough rule of thumb is use an A size under 100 hours of engine run time and use a B size over 100 hours of engine run time. Its ALWAYS better to have a bit too much clearance than not enough, so if in doubt use an A size.

Additional information

Weight2.5 kg
Piston Size

,